[CLOSED] Sleep and Sit emotes positioning

[Kavar Starkiller]

I think this is a bug for me...but whenever i was /emsleep my character ends up going through the floor..help?

[Arikakon Genkal]

I got that, and Samoon got it, too. The only way out is to /kill and that's not very friendly to the RP...

[Wesley Ryor]

Its not a bug. Its a glitch caused by the small model you are using. Becuase the RPMod was tested on full-grown models the (amsit - now emsit ) and.. (amsleep - now emsleep ) Were fixed so you wouldn't hover a foot off the ground but would actually touch the surface. The small model you are using causes it to lower below ground. An unfortunate side-effect, a solution is still being forumlated.

Also, please follow proper posting protocol for bugs in the future..

The Report:

Before anything, check if anyone already reported the bug. If yes, you can reply to the existing thread if you think you can add useful information or confirm the bug.

A bug report must be very detailed to define the problem as precisely as possible.

To be solved, a bug must be reproducible. Make sure to describe the steps to follow to reproduce it.

The thread's title must be explicit, not just 'Bug' or 'Problem'. Also, please add [NEW] at the beginning of the title (see below)

[Kavar Starkiller]

ok, thanks.

[Raz Rear]

Maybe i found a way to avoid that. Just do the emote when you 'Stand' on air near chair or on what you can stand, then do emote. You'll be sleeping on the floor.

[Tinthros Vos]

Or try a surface that doesn't do that.

[Kavar Starkiller]

Like...?

[Kavar Starkiller]

Ah, nevermind, I found a surface. Yay!

[Soh Raun]

Bug fixed.