Page 1 of 1

[CLOSED] Sleep and Sit emotes positioning

Posted: Wed Jul 04, 2007 8:17 pm
by Kavar Starkiller
I think this is a bug for me...but whenever i was /emsleep my character ends up going through the floor..help?

Posted: Wed Jul 04, 2007 8:20 pm
by Arikakon Genkal
I got that, and Samoon got it, too. The only way out is to /kill and that's not very friendly to the RP...

Posted: Wed Jul 04, 2007 8:21 pm
by Wesley Ryor
Its not a bug. Its a glitch caused by the small model you are using. Becuase the RPMod was tested on full-grown models the (amsit - now emsit ) and.. (amsleep - now emsleep ) Were fixed so you wouldn't hover a foot off the ground but would actually touch the surface. The small model you are using causes it to lower below ground. An unfortunate side-effect, a solution is still being forumlated.

Also, please follow proper posting protocol for bugs in the future..


The Report:

Before anything, check if anyone already reported the bug. If yes, you can reply to the existing thread if you think you can add useful information or confirm the bug.

A bug report must be very detailed to define the problem as precisely as possible.

To be solved, a bug must be reproducible. Make sure to describe the steps to follow to reproduce it.

The thread's title must be explicit, not just 'Bug' or 'Problem'. Also, please add [NEW] at the beginning of the title (see below)

Posted: Wed Jul 04, 2007 10:34 pm
by Kavar Starkiller
ok, thanks.

Posted: Fri Jul 06, 2007 11:11 am
by Raz Rear
Maybe i found a way to avoid that. Just do the emote when you 'Stand' on air near chair or on what you can stand, then do emote. You'll be sleeping on the floor.

Posted: Fri Jul 06, 2007 3:20 pm
by Tinthros Vos
Or try a surface that doesn't do that.

Posted: Fri Jul 06, 2007 6:56 pm
by Kavar Starkiller
Like...?

Posted: Tue Jul 10, 2007 7:36 am
by Kavar Starkiller
Ah, nevermind, I found a surface. Yay! :D

Posted: Sat Aug 25, 2007 8:39 am
by Soh Raun
Bug fixed.